Skip to main content
18.97.14.81

Modeling and simulation of continuous powder blending applied to a continuous direct compression process

By Galbraith, Shaun C.; Liu, Huolong; Cha, Bumjoon; Park, Seo-Young; Huang, Zhuangrong; Yoon, Seongkyu

Published on

Abstract

Continuous manufacturing techniques are increasingly being adopted in the pharmaceutical industry and powder blending is a key operation for solid-dosage tablets. A modeling methodology involving axial and radial tanks-in-series flowsheet models is developed to describe the residence time distribution (RTD) and blend uniformity of a commercial powder blending system. Process data for a six-component formulation processed in a continuous direct compression line (GEA Pharma Systems) is used to test the methodology. Impulse tests were used to generate experimental RTDs which are used along with parameter estimation to determine the number of axial tanks in the flowsheet. The weighted residual from the parameter estimation was less than the (2) value at a 95% confidence indicating a good fit between the model and measured data. In-silico impulse tests showed the tanks-in-series modeling methodology could successfully describe the RTD behavior of the blenders along with blend uniformity through the use of radial tanks. The simulation output for both impulse weight percentage and blend uniformity were within the experimentally observed variance.

Journal

Pharmaceutical Development and Technology. Volume 23, 10, 2018, 1097-1107

DOI

10.1080/10837450.2018.1425429

Type of publication

Peer-reviewed journal

Affiliations

  • University of Massachusetts Lowell

Article Classification

Research article

Classification Areas

  • Oral solid dose

Tags