-
Development of a novel method for the continuous blending of carrier-based dry powders for inhalation using a co-rotating twin-screw extruder
23 Jul 2024 | Contributor(s):: Spahn, Jamie E., Hefnawy, Amr, Smyth, Hugh D. C., Zhang, Feng
Twin-screw extruders are useful in tuning certain product characteristics due to the ability to greatly modify screw profiles as well as operating parameters. However, their use has not yet been applied to dry powder inhalation. In this study the feasibility of using a twin-screw extruder to...
-
Validation of a continuous granulation process using a twin-screw extruder
09 Jun 2023 | Contributor(s):: Van Melkebeke, B., Vervaet, C., Remon, J. P.
Using twin-screw granulation as particle size enlargement technique, the effect of modifying the screw configuration (number of mixing zones, configuration of kneading block) on granule quality, tablet properties and mixing efficiency was investigated. The amount of oversized agglomerates and...
-
Rolling phenomenon in twin screw granulation with controlled-release excipients
09 Jun 2023 | Contributor(s):: Thompson, M. R., O'Donnell, K. P.
The developed knowledge regarding use of twin screw granulators for continuous wet granulation has been primarily limited to immediate release formulations in the literature. The present study highlights an issue previously unreported for wet granulation with twin screw extruders when using...
-
Influence of filler selection on twin screw foam granulation
09 Jun 2023 | Contributor(s):: Rocca, K. E., Weatherley, S., Sheskey, P. J., Thompson, M. R.
The influence of filler selection in wet granulation was studied for the novel case where the binder is delivered as an unstable, semi-rigid aqueous foam to an extrusion process. The work primarily examined the impact of differing concentrations of microcrystalline cellulose (Avicel PH (R) 101)...
-
Influence of granulation temperature on particle size distribution of granules in twin-screw granulation (TSG)
09 Jun 2023 | Contributor(s):: Ito, Akihiko, Kleinebudde, Peter
This study investigated an influence of granulation temperature during twin-screw granulation (TSG) on particle size distributions (PSDs). The influence of the granulation temperature on granule size distributions varied, depending on the liquid to solid (L/S) ratio, the kind of binders, the...
-
Dry Powder Mixing Is Feasible in Continuous Twin Screw Extruder: Towards Lean Extrusion Process for Oral Solid Dosage Manufacturing
09 Jun 2023 | Contributor(s):: Mateo-Ortiz, Daniel, Villanueva-Lopez, Vladimir, Muddu, Shashank Venkat, Doddridge, Gregory D., Alhasson, Dana, Dennis, Michael C.
Using discrete element method (DEM) modeling and near-infrared (NIR) spectroscopy, the feasibility of powder mixing in the initial pre-melting zones of a twin screw extruder using two independent feeders was studied. Previous work in the pharmaceutical and food industry has focused on mixing when...
-
Development and Optimization of a Wet Granulation Process at Elevated Temperature for a Poorly Compactible Drug Using Twin Screw Extruder for Continuous Manufacturing
09 Jun 2023 | Contributor(s):: Meena, Anuprabha K, Desai, Divyakant, Serajuddin,, Abu T. M.
The objective of this study was to enhance tabletability of a poorly compactible drug, acetaminophen, by wet granulation using twin screw extruder at high temperature. It was desired that there would be minimum amounts of excipients used and the granules obtained after extrusion would be dry and...