Effects of Process and Design Parameters on Granule Size Distribution in a Continuous High Shear Granulation Process
Category
Published on CMKC
Abstract
Wet granulation is widely used in the pharmaceutical industry. This advantageous technology is capable of enhancing compression and powder handling, decreasing ingredient segregation, and promoting blend and content uniformity. Currently, a high level of interest exists in the continuous version of this technology, both by the US Food and Drug Administration (FDA), and by pharmaceutical manufacturers. In this paper, a continuous high shear wet granulation process was examined based on a placebo formulation comprising 70% a,-lactose monohydrate and 30% microcrystalline cellulose (AvicelA (R) PH101). Granulation was then carried out in a continuous high shear mixer granulator, Glatt GCG 70. The impact of two process variables (rotation speed and liquid/solid (L/S) ratio) and two design parameters (blade configuration and nozzle position) were evaluated via an I-optimal design. Multi-factor analysis of variance (ANOVA) indicated that rotation speed and L/S ratio dominated the granulation process and had the most significant effects on granule size distribution (GSD). The largest granule mass median diameter was obtained at the lowest rotation speed and highest L/S ratio. The granulation mechanism underlying this continuous process was examined using a wetting and nucleation regime map. For the cases studied here, the mechanical dispersion regime controlled the formation of granule nuclei, leading to a broad GSD and a limited growth ratio.
Journal
DOI
Type of publication
Affiliations
- Rutgers, The State University of New Jersey
Article Classification
Classification Areas
- Oral solid dose
- Process characterization